Description

– DELIMBE SALT SPREADER –

Electric road salt spreader, 4-meter working width, suitable for dry or wet salt, available in 80 and 120-liter sizes.

DESCRIPTION OF THE SALT SPREADER

• The DELIMBE T11 road spreader is suitable for both dry and wet salt.
• It is placed at the rear of the vehicle (utility car, quad, small truck).
• 4-metre working width (stainless steel auger and 4-metre spreading plate).
• Spreader operating speed between 5 and 15 km/h.
• Distribution tray and auger powered by two sealed 12-volt electric motors.
• Adjustable salt/sand flow rate with scale from 0 to 30.
• All-aluminium spreader and 80 and 120-litre polyethylene tanks.
• Worm gear 20 A and distribution plate 15 A.

ROAD SALT SPREADER OPTIONS

• The spreader must be fitted with a control box, of which there are two models: the standard box for start-up and the width adjustment box, which can also be used to vary the salt spreading width between 2 and 4 meters.
• Possibility of modulating the platform block to direct spreading to the right or left.
• Various hitch types are available, depending on hopper capacity: 3-point hitch, self-mounted on ball or cart.

*Tips :

• Used as a preventive measure at 4g/m², the tank’s capacity means you can salt a 6600 m road 4 m wide without filling the tank.

• Used as a preventive measure at 10g/m², the tank’s capacity means you can salt a 5000 m road 4 m wide without filling the tank.

• At 15g/m² (dose not to be exceeded), the curative treatment area is 3330 m for a 4 m wide road. An increase in dosage is no guarantee of greater effectiveness (it’s often the water that’s lacking most).

• 7 to 10 g/m² are sufficient for preventive spraying, and 10 to 15 g/m² for curative spraying. Moreover, it’s better to spread 2×15 g/m² than 1×30 g/m².